SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2015SILVERADO 1500 HIGH COUNTRY, 5.3L ENG VIN C, RWD, GASREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 2165 (INSTRUMENT PANEL TRIM AND CONSOLE TRIM)REPAIR INSTRUCTIONSFRONT FLOOR CONSOLE REPLACEMENT (CADILLAC)
2015 Chevrolet Silverado 1500 High Country, 5.3L Eng VIN C, RWD, Gas

Front Floor Console Replacement (Cadillac)

2015 Chevrolet Silverado 1500 High Country, 5.3L Eng VIN C, RWD, GasSECTION Front Floor Console Replacement (Cadillac)
WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2012 GMC Yukon XL, 2012 GMC Yukon, 2012 Chevrolet Tahoe, 2012 Chevrolet Suburban, and 2012 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: View Of Front Floor Console Assembly & Bolts
GM1704190Courtesy of GENERAL MOTORS COMPANY
Front Floor Console Replacement (Cadillac)

Callout Component Name

Preliminary Procedures

  1. Remove the 2 front seats. Refer to Front Seat Replacement - Bucket (without HP2) , Front Seat Replacement - Bucket (with HP2) .
  2. Remove the right and left front floor consoleside trim front panels. Refer to Front Floor Console Side Trim Front Panel Replacement - Left Side (Cadillac) , and Front Floor Console Side Trim Front Panel Replacement - Right Side (Cadillac) .
  3. Remove the front floor console bezel. Refer to Floor Console Bezel Replacement (Except Cadillac) , Floor Console Bezel Replacement (Cadillac) .
1 Front Floor Console Assembly Bolt/Screw
CAUTION:

Refer to Fastener Caution .


Tighten 
2 N.m (18 lb in)
2 Front Floor Console Assembly
  1. Disconnect the electrical connectors to the console assembly.
  2. With the aid of an assistant, remove the console from the vehicle.
  3. If replacing the console assembly, transfer all necessary components.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.