Front of Vehicle (GMC) Components

2015 Chevrolet Silverado 1500 High Country, 5.3L Eng VIN C, RWD, GasSECTION Front of Vehicle (GMC) Components
Front of Vehicle (GMC) Components

Items
1: E4P Park/Turn Signal Lamp - Right (Z88) E4P Park/Turn Signal Lamp - Right (Z88)
2: E4J Park Lamp - Left Front (Z88 with SLT) E4J Park Lamp - Left Front
3: T4M Radio Antenna T4M Radio Antenna
4: T4G Cellular Phone, Navigation, and Digital Radio Antenna T4H Digital Radio Antenna (except UE1)
5: E4K Park Lamp - Right Front (Z88 with SLT) E4K Park Lamp - Right Front
6: E4G Headlamp - Left Low Beam E4G Headlamp - Left Low Beam
7: E4N Park/Turn Signal Lamp - Left (Z88) E4N Park/Turn Signal Lamp - Left (Z88)
8: E4AD Park/Daytime Running Lamp - Right (Z88 with SLT) E4AD Park/Daytime Running Lamp - Right
9: E29LF Fog Lamp - Left Front (T3U) E29LF Fog Lamp - Left Front
10: B78A Front Object Sensor - Left Outer (UD5) B78A Front Object Sensor - Left Outer
11: B78C Front Object Sensor - Left Middle (UD5) B78C Front Object Sensor - Left Middle
12: B78D Front Object Sensor - Right Middle (UD5) B78D Front Object Sensor - Right Middle
13: B78A Front Object Sensor - Left Outer (UD5) B78A Front Object Sensor - Left Outer
14: E29RF Fog Lamp - Right Front (T3U) E29RF Fog Lamp - Right Front
15: B9 Ambient Air Temperature Sensor B9 Ambient Air Temperature Sensor
16: E4AC Park/Daytime Running Lamp - Left (Z88 with SLT) E4AC Park/Daytime Running Lamp - Left (Z88)
17: E4H Headlamp - Right Low Beam E4H Headlamp - Right Low Beam
Fig 1: Front of Vehicle (GMC) Components
GM3634114Courtesy of GENERAL MOTORS COMPANY
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.