Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

SYS.OK|MANUAL.DB● LIVE

HOMESERVICE MANUALSCHEVROLET2015SILVERADO 1500 HIGH COUNTRY, 5.3L ENG VIN C, RWD, GASREPAIR AND DIAGNOSIS (SINGLE PAGE)ACCESSORIES & EQUIPMENTCOLLISION/AVOIDANCEOBJECT DETECTION AND PEDESTRIAN PROTECTION SYSTEMREPAIR INSTRUCTIONSFRONT PARKING ASSIST ALARM SENSOR REPLACEMENT (CENTER)REMOVAL PROCEDURE

2015 Chevrolet Silverado 1500 High Country, 5.3L Eng VIN C, RWD, Gas

Removal Procedure

2015 Chevrolet Silverado 1500 High Country, 5.3L Eng VIN C, RWD, GasSECTION Removal Procedure

Fig 1: Identifying Rear Object Sensor Housing

Courtesy of GENERAL MOTORS COMPANY

Access the front parking assist alarm sensor from under the front impact bar.
Disconnect electrical from the front object alarm sensor.
Lift the locking tabs on the housing and remove the front object alarm sensor.

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready Tools Free Quote Check Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.