Circuit/System Verification

2015 Chevrolet Silverado 1500 High Country, 5.3L Eng VIN C, RWD, GasSECTION Circuit/System Verification
  1. Verify there is no debris on the B87 Rearview Camera lens and that the bezel and bezel seal are not damaged.
    • If debris is found on the lens 

      Clean the lens. If the lens, bezel, or bezel seal are damaged, replace as necessary.

    • If there is no debris on the lens 
  2. Engine running, transmission in R.
  3. Verify the backup lamps are illuminated.
    • If the backup lamps are illuminated 
  4. Engine running, transmission in R.
  5. Verify a clear rear vision image is displayed on the P17 Info Display Module.
    • If a clear image is not displayed 

      Refer to Circuit/System Testing.

    • If a clear image is displayed 
  6. All OK.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • You smell fuel, burning insulation, or see smoke.
  • Brakes feel soft, pull hard to one side, or make grinding noises.
  • The engine overheats, stalls repeatedly, or misfires under load.
  • You are missing required tools, torque specs, or safe lifting equipment.
  • You are not confident in the next step or safety outcome.