Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2015EXPRESS 2500 BASE, VAN CARGO, 6.0L ENG VIN BREPAIR AND DIAGNOSISENGINE PERFORMANCESYSTEMDATA COMMUNICATION SYSTEMREPAIR INSTRUCTIONSBODY CONTROL MODULE REPLACEMENTREMOVAL PROCEDURE
2015 Chevrolet Express 2500 Base, Van Cargo, 6.0L Eng VIN B
Removal Procedure
2015 Chevrolet Express 2500 Base, Van Cargo, 6.0L Eng VIN BSECTION Removal Procedure
- Remove the right side knee bolster trim panel. Refer to Passenger Knee Bolster Replacement .
- Disconnect the electrical connectors (2) from the body control module (BCM) (1).
- Release the tabs (2) retaining the BCM (1) to the bracket.
- Remove the BCM (1) from the vehicle.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.