Steering Column Housing Replacement

2015 Chevrolet Express 2500 Base, Van Cargo Extended, 6.0L Eng VIN BSECTION Steering Column Housing Replacement
Fig 1: Locating Steering Column Tilt Head Housing
GM2074178Courtesy of GENERAL MOTORS COMPANY
Callout Component Name

Preliminary Procedures

  1. Remove the steering column tilt spring. Refer to Steering Column Tilt Spring Replacement .
  2. Remove the ignition lock cylinder case. Refer to Ignition Lock Cylinder Case Replacement .
1 Steering Column Pivot Pin (Qty: 2)

Procedure

  1. Use remover J 21854-01  pivot pin remover to remove the steering column pivot pins.
  2. Before installing, lubricate the steering column pivot pins with the GM recommended lubricant.
  3. Once installed, stake the steering column in 3 locations around each steering column pivot pin.

Special Tools 
J 21854-01  Pivot Pin Remover
2 Steering Column Tilt Head
Procedure 
Transfer the turn signal switch bracket if needed.
TIP:  Do not allow any debris into the steering column tilt head.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • You smell fuel, burning insulation, or see smoke.
  • Brakes feel soft, pull hard to one side, or make grinding noises.
  • The engine overheats, stalls repeatedly, or misfires under load.
  • You are missing required tools, torque specs, or safe lifting equipment.
  • You are not confident in the next step or safety outcome.