Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2015EXPRESS 2500 BASE, VAN CARGO EXTENDED, 6.0L ENG VIN BREPAIR AND DIAGNOSISDRIVELINES & AXLESDIFFERENTIALS & DRIVE AXLESFRONT DRIVE AXLESPECIAL TOOLS AND EQUIPMENTSPECIAL TOOLS
2015 Chevrolet Express 2500 Base, Van Cargo Extended, 6.0L Eng VIN B
Special Tools
2015 Chevrolet Express 2500 Base, Van Cargo Extended, 6.0L Eng VIN BSECTION Special Tools
| Illustration | Tool Number/Description |
|---|---|
| J 2619-01 Slide Hammer |
|
| J 8001 Dial Indicator Set |
|
| J 8092 Driver Handle |
|
| J 8107-2 Side Bearing Puller Pilot |
|
| J 8614-01 Flange and Pulley Holding Tool |
|
| J 22888-D Side Bearing Remover Kit |
|
| J 22888-A Universal Two Jaw Puller |
|
| J 22912-01 Rear Pinion and Axle Bearing Remover |
|
| J 23423-A Case Bearing Race Installer |
|
| J 29369-1 Bushing and Bearing Remover |
|
| J 29763 Static Timing Gauge |
|
| J 33782 Pinion Oil Seal Installer |
|
| J 33785 Pinion Bearing Installer |
|
| J 33790 Differential Side Bearing Installer |
|
| J 33838 Pinion Setting Gauge |
|
| J 42211 Axle Bearing Installer |
|
| J 42738 Seal Installer |
|
| J 45224 Side Bearing Adjuster |
|
| J 45228 Pinion Bearing Cup Remover/Installer |
|
| J 45232 Differential Bearing Adjuster Needle Bearing Installer - LH |
|
| J 45234 Pinion Remover - 7.25 Inch Axle |
|
| J 45850 Front Axle Bushing Remover/Installer |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.