SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2015EXPRESS 2500 BASE, VAN CARGO EXTENDED, 6.0L ENG VIN BREPAIR AND DIAGNOSIS (SINGLE PAGE)BRAKESMECHANICAL - HYDRAULICDISC BRAKE SYSTEMREPAIR INSTRUCTIONSFRONT DISC BRAKE PADS REPLACEMENTFRONT DISC BRAKE PADS REPLACEMENT (JH6)INSTALLATION PROCEDURE
2015 Chevrolet Express 2500 Base, Van Cargo Extended, 6.0L Eng VIN B

Installation Procedure

2015 Chevrolet Express 2500 Base, Van Cargo Extended, 6.0L Eng VIN BSECTION Installation Procedure
    Fig 1: View Of Lower Brake Caliper Guide Pin Bolt
    GM1700050Courtesy of GENERAL MOTORS COMPANY
  1. Apply a very thin coating of high temperature silicone brake lubricant to the pad mating surfaces of the caliper bracket only.
  2. Install the spring clips (4) to the mounting bracket.
    • Install the NEW spring clips if replacing the brake pads.
    • Install the original spring clips in their original position if installing the original brake pads.
  3. If installing new brake pads, remove the adhesive backing paper from the brake pad insulators.
    4. NOTE:

    If installing the original brake pads, position the brake pads as marked during the removal procedure.

  4. Install the brake pads (3).
  5. Rotate the brake caliper (2) into the proper position on the mounting bracket (5).
    6. Fig 2: Using Open End Wrench To Loosen Brake Caliper Guide Pin Bolt
    GM1697372Courtesy of GENERAL MOTORS COMPANY
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.