Instrument Panel Cluster Trim Plate Bezel Replacement

2015 Chevrolet Express 2500 Base, Van Cargo Extended, 6.0L Eng VIN BSECTION Instrument Panel Cluster Trim Plate Bezel Replacement
Fig 1: Instrument Panel Cluster Trim Plate Bezel
GM1891937Courtesy of GENERAL MOTORS COMPANY
Callout Component Name

Preliminary Procedures

  1. Remove both drivers and passenger knee bolsters. Refer to Passenger Knee Bolster ReplacementΒ , and Driver Knee Bolster ReplacementΒ .
  2. Remove the drivers knee bolster bracket. Refer to Driver Knee Bolster Bracket ReplacementΒ .
  3. Remove the steering column nuts securing the steering column to the instrument panel carrier and lower the entire column to the floor and position out of the way. Refer to Steering Column Replacement .
1 Instrument Panel Cluster Trim Plate Assembly

Procedure

  1. Disconnect the electrical connections.
  2. When replacing the cluster trim panel, transfer all necessary components.
2 Retainer Clips (Qty: 17)
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.