Back Body Opening Upper Applique Replacement

2015 Chevrolet Express 2500 Base, Van Cargo Extended, 6.0L Eng VIN BSECTION Back Body Opening Upper Applique Replacement
Fig 1: Back Body Opening Upper Applique
GM1892787Courtesy of GENERAL MOTORS COMPANY
Callout Component Name

Preliminary Procedure

  1. Open the rear access doors.
  2. Remove the rear back body opening side applique. Refer to Back Body Opening Side Applique and Tail Lamp Replacement .
1 Back Body Opening Upper Applique Screw (Qty: 2)
CAUTION:

Refer to Fastener Caution .


Tighten 
2 N.m (18 lb in)
2 Back Body Opening Upper Applique Nut (Qty: 4)
Tighten 
6 N.m (53 lb in)
3 High Mounted Stop Lamp Electrical Harness and Grommet
TIP:  Disconnect the harness grommet from the body then disconnect the electrical connector.
4 Back Body Opening Upper Applique
TIP:  Transfer the high mounted stop lamp. Refer to High Mount Stop Lamp Replacement .
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • You smell fuel, burning insulation, or see smoke.
  • Brakes feel soft, pull hard to one side, or make grinding noises.
  • The engine overheats, stalls repeatedly, or misfires under load.
  • You are missing required tools, torque specs, or safe lifting equipment.
  • You are not confident in the next step or safety outcome.