Inside Rearview Mirror Replacement

2015 Chevrolet Express 2500 Base, Van Cargo Extended, 6.0L Eng VIN BSECTION Inside Rearview Mirror Replacement
Fig 1: Inside Rearview Mirror
GM3228847Courtesy of GENERAL MOTORS COMPANY
Callout Component Name
1 Inside Rearview Mirror Screw
CAUTION:

Refer to Fastener Caution .


Procedure 
Remove the inside rearview mirror cover, if equipped.
Tighten 
2 N.m (18 lb in)
2 Inside Rearview Mirror

Procedure

  1. Disconnect the electrical connector, if equipped.
  2. Adjust the mirror to the full upward position.
  3. Slide the mirror upward off of the rearview mirror button.
  4. Refer to Control Module References for programming and setup information.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • You smell fuel, burning insulation, or see smoke.
  • Brakes feel soft, pull hard to one side, or make grinding noises.
  • The engine overheats, stalls repeatedly, or misfires under load.
  • You are missing required tools, torque specs, or safe lifting equipment.
  • You are not confident in the next step or safety outcome.