Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DBâ—Ź LIVE
HOMESERVICE MANUALSCHEVROLET2015EXPRESS 2500 BASE, VAN CARGO EXTENDED, 6.0L ENG VIN BREPAIR AND DIAGNOSIS (SINGLE PAGE)ACCESSORIES & EQUIPMENTDRIVERS ASSISTANCE SYSTEMS - ADASOBJECT DETECTION AND PEDESTRIAN PROTECTION SYSTEMDIAGNOSTIC INFORMATION AND PROCEDURES (OBJECT DETECTION AND PEDESTRIAN PROTECTION SYSTEM)REAR VISION CAMERA SYSTEM MALFUNCTION (OBJECT DETECTION AND PEDESTRIAN PROTECTION SYSTEM)REAR VISION CAMERA SYSTEM MALFUNCTION (WITH NAVIGATION RADIO UYS)(OBJECT DETECTION AND PEDESTRIAN PROTECTION SYSTEM)CIRCUIT/SYSTEM VERIFICATION (OBJECT DETECTION AND PEDESTRIAN PROTECTION SYSTEM)
2015 Chevrolet Express 2500 Base, Van Cargo Extended, 6.0L Eng VIN B
Circuit/System Verification (Object Detection And Pedestrian Protection System)
2015 Chevrolet Express 2500 Base, Van Cargo Extended, 6.0L Eng VIN BSECTION Circuit/System Verification (Object Detection And Pedestrian Protection System)
- Ignition ON.
- Verify that DTC B2545 is not set.
- If the DTC is setÂ
Refer to DTC B2545 .
- If the DTC is not setÂ
- If the DTC is setÂ
- Verify the rearview camera has no debris on the lens and that the bezel or bezel seal is not damaged.
- If debris is found on the lensÂ
Clean the lens. If the lens, bezel, or bezel seal are damaged, replace as necessary.
- If no debris on the lensÂ
- If debris is found on the lensÂ
- Ignition ON, transmission in REVERSE.
- Verify the backup lamps are On.
- If the backup lamps are not ONÂ
Refer to Backup Lamps Malfunction .
- If the backup lamps are ONÂ
- If the backup lamps are not ONÂ
- Engine running, transmission in REVERSE.
- Verify a clear rear vision image is displayed on the radio.
- If a clear image is not displayedÂ
Refer to Circuit/System Testing.
- If a clear image is displayedÂ
- If a clear image is not displayedÂ
- All OK.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.