SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2015EXPRESS 2500 BASE, VAN CARGO EXTENDED, 6.0L ENG VIN BREPAIR AND DIAGNOSIS (SINGLE PAGE)ACCESSORIES & EQUIPMENTDRIVERS ASSISTANCE SYSTEMS - ADASOBJECT DETECTION AND PEDESTRIAN PROTECTION SYSTEMDIAGNOSTIC INFORMATION AND PROCEDURES (OBJECT DETECTION AND PEDESTRIAN PROTECTION SYSTEM)PARKING ASSIST SYSTEM MALFUNCTION (OBJECT DETECTION AND PEDESTRIAN PROTECTION SYSTEM)CIRCUIT/SYSTEM TESTING (OBJECT DETECTION AND PEDESTRIAN PROTECTION SYSTEM)
2015 Chevrolet Express 2500 Base, Van Cargo Extended, 6.0L Eng VIN B

Circuit/System Testing (Object Detection And Pedestrian Protection System)

2015 Chevrolet Express 2500 Base, Van Cargo Extended, 6.0L Eng VIN BSECTION Circuit/System Testing (Object Detection And Pedestrian Protection System)

Manual Transmission

  1. Engine running, transmission in REVERSE.
  2. Verify the scan tool Calculated Transmission Range parameter is Reverse.
    • If parameter is Reverse 
  3. Verify the scan tool Park Assist System Status parameter displays Enable.
      NOTE:

      After completing the next step the vehicle might need to be driven in the forward direction at speed greater than 40 km/h (25 mph).

    • If status is not Enable 

      Refer to Diagnostic Aids and the scan tool Park Assist Disable History parameters to determine the cause of the inhibit.

    • If status is Enable 
  4. Replace the K41R Rear Parking Assist Control Module.

Automatic Transmission

  1. Engine running, transmission in REVERSE.
  2. Verify the scan tool Park Assist System Status parameter displays Enable.
      NOTE:

      After completing the next step the vehicle might need to be driven in the forward direction at speed greater than 40 km/h (25 mph).

    • If status is not Enable 

      Refer to Diagnostic Aids and the scan tool Park Assist Disable History parameters to determine the cause of the inhibit.

    • If status is Enable 
  3. Replace the K41R Rear Parking Assist Control Module.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.