Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2015EXPRESS 2500 BASE, VAN CARGO EXTENDED, 6.0L ENG VIN BREPAIR AND DIAGNOSIS (SINGLE PAGE)ACCESSORIES & EQUIPMENTCOMMUNICATION DEVICESPROGRAMMING AND SETUP - ALL SYSTEMSREPAIR INSTRUCTIONSK20 ENGINE CONTROL MODULE: PROGRAMMING AND SETUPK20 ENGINE CONTROL MODULE: PROGRAMMING AND SETUP (GASOLINE ENGINES)ECM REPLACEMENT
2015 Chevrolet Express 2500 Base, Van Cargo Extended, 6.0L Eng VIN B
ECM Replacement
2015 Chevrolet Express 2500 Base, Van Cargo Extended, 6.0L Eng VIN BSECTION ECM Replacement
If the engine control module (ECM) is replaced, the following procedures must be performed:
- The ECM Reprogramming-Refer to Service Programming System (SPS) .
- The CKP Variation Learn-Refer to Crankshaft Position System Variation Learn .
- The Throttle Learn procedure-Refer to Q38 Throttle Body: Throttle/Idle Learn .
- The Theft Deterrent Programming-Refer to Theft Deterrent Module Programming and Setup .
- Engine Oil Life Remaining-When available, use a scan tool to reset the Engine Oil Life Remaining back to the original percentage recorded before the module was replaced.
- Transmission Fluid Life Remaining-When available, use a scan tool to reset the Transmission Fluid Life Remaining back to the original percentage recorded before the module was replaced.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.