SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2015CRUZE ECO, AUTOMATIC TRANSREPAIR AND DIAGNOSISELECTRICALINSTRUMENT PANEL SYSTEM DISPLAYS AND GAUGESDIAGNOSTIC INFORMATION AND PROCEDURESSPEEDOMETER AND/OR ODOMETER MALFUNCTIONCIRCUIT/SYSTEM TESTING
2015 Chevrolet Cruze Eco, Automatic Trans

Circuit/System Testing

2015 Chevrolet Cruze Eco, Automatic TransSECTION Circuit/System Testing
NOTE:
  • Circuit/System Verification  must be performed before proceeding with Circuit/System Testing.
  • If there are multiple modules not original to the vehicle and are not new correctly configured service parts, SPS may not be able to proper read or recover the vehicle odometer value. Follow government rules and documentation (including vehicle identification) regarding inaccurate/unknown odometer values.

Instrument Cluster is Showing "----" (Dashes) 

Correcting VIN mismatch - odometer is still Inactive.

  1. Verify the vehicle odometer status with a scan tool. The reading should be Inactive.
    • If the reading is Active 

      Refer to Correcting VIN mismatch - odometer Active.

    • If the reading is Inactive 
  2. Using the scan tool, verify the BCM VIN matches the vehicle VIN placard.
    • If the VIN does not match 

      Reprogram the BCM, then proceed to Step  3.

    • If the VIN matches 
  3. Using the scan tool, verify the instrument cluster VIN matches the vehicle VIN placard.
    • If the VIN does not match 

      Reprogram the instrument cluster. Then proceed with step  4.

    • If the VIN matches 
  4. Ignition ON, verify the instrument cluster is displaying the correct value.
    • If the instrument cluster is still displaying "----" (dashes) 

      Replace the P16 Instrument Cluster.

Instrument Cluster is Showing "----" (Dashes) 

Correcting VIN mismatch - odometer is Active.

  1. Verify the vehicle odometer status with a scan tool. The reading should be Inactive.
    • If the reading is Inactive 

      Refer to Correcting VIN mismatch - odometer Inactive.

    • If the reading is Active 
  2. Using the scan tool, verify the instrument cluster VIN matches the vehicle's VIN placard.
    • If the VIN does not match 

      Reprogram the Instrument Cluster. Then proceed with step  3.

    • If the VIN matches 
  3. Perform the BCM setup procedure in SPS.
  4. Ignition ON, verify the instrument cluster is displaying the correct value.
    • If the instrument cluster is still displaying "----" (dashes) 

      Replace the P16 Instrument Cluster.

    • If instrument cluster is displaying the correct value 
  5. All OK.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.