Circuit/System Verification

2015 Chevrolet Cruze Eco, Automatic TransSECTION Circuit/System Verification
  1. Ignition ON.
  2. Verify that DTC B3119, B3120 or B3121 is not set.
    • If none of the DTCs are set 
  3. Verify that the vehicle key is correct for the vehicle. This can be accomplished by comparing the part number printed on the key to the appropriate part number in the parts catalog.
    • If the vehicle key is incorrect 

      Replace the vehicle key.

    • If the vehicle key is correct 
  4. Verify the scan tool Exterior Driver Door Handle Switch, Exterior Passenger Door Handle Switch and Trunk Lid Exterior Unlatch Switch parameters change between Active and Inactive while operating their respective exterior door handle button/rear closure touch pad.
    • If all of the parameters change 
  5. Lock the vehicle using the keyless entry transmitter.
  6. Verify that each door and the rear compartment unlocks and opens by approaching the vehicle with a valid transmitter and operating their respective exterior door handle button/rear closure touch pad.
    • If both doors and the rear compartment unlocks/unlatches and opens 
  7. All OK.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.