Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2015CRUZE ECO, AUTOMATIC TRANSREPAIR AND DIAGNOSIS (SINGLE PAGE)QUICK LOOKUPSWIRING DIAGRAMSWIRING SYSTEMS AND POWER MANAGEMENT - COMPONENT CONNECTOR END VIEWS - A3L TO B88DCOMPONENT CONNECTOR END VIEWSA24D DOOR HANDLE ASSEMBLY - DRIVER EXTERIOR (ATH)
2015 Chevrolet Cruze Eco, Automatic Trans
A24D Door Handle Assembly - Driver Exterior (ATH)
2015 Chevrolet Cruze Eco, Automatic TransSECTION A24D Door Handle Assembly - Driver Exterior (ATH)
Connector Part Information
|
Terminal Part Information
| Terminal Type ID | Terminated Lead | Diagnostic Test Probe | Terminal Removal Tool | Service Terminal | Tray | Core Crimp | Insulation Crimp |
|---|---|---|---|---|---|---|---|
| I | Not Required | J-35616-65B (LT BU) | No Tool Required | Not Required | Not Required | Not Required | Not Required |
| Pin | Size | Color | Circuit | Function | Terminal Type ID | Option |
|---|---|---|---|---|---|---|
| 1 | 0.5 | VT | 3560 | Passive Entry Driver Door Antenna Signal Hi | I | - |
| 2 | 0.5 | VT/GY | 3561 | Passive Entry Driver Door Antenna Signal Lo | I | - |
| 3 | 0.35 | L-GN/WH | 6655 | Driver Door Unlatch Switch Signal | I | - |
| 4 | 0.35 | BK | 350 | Ground | I | - |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.