SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2015CRUZE ECO, AUTOMATIC TRANSREPAIR AND DIAGNOSIS (SINGLE PAGE)ACCESSORIES & EQUIPMENTINFOTAINMENTCELLULAR SYSTEM, ENTERTAINMENT SYSTEM AND NAVIGATION SYSTEMREPAIR INSTRUCTIONSDIGITAL RADIO, MOBILE TELEPHONE AND VEHICLE LOCATION ANTENNA CABLE REPLACEMENT (DIGITAL SATELLITE CABLE)
2015 Chevrolet Cruze Eco, Automatic Trans

Digital Radio, Mobile Telephone and Vehicle Location Antenna Cable Replacement (Digital Satellite Cable)

2015 Chevrolet Cruze Eco, Automatic TransSECTION Digital Radio, Mobile Telephone and Vehicle Location Antenna Cable Replacement (Digital Satellite Cable)
Fig 1: Radio, Mobile Telephone And Vehicle Location Antenna Cable
GM2699303Courtesy of GENERAL MOTORS COMPANY
Callout Component Name

Preliminary Procedures

  1. Remove the front floor panel carpet. Refer to Front Floor Panel Carpet Replacement .
  2. Remove the headlining trim panel. Refer to Headlining Trim Panel Replacement (with Sunroof) and Headlining Trim Panel Replacement (without Sunroof) .
1 Radio, Mobile Telephone and Vehicle Location Antenna Cable

Procedures

  1. Locate the radio, mobile telephone and vehicle location antenna cable in the body wiring harness assembly.
  2. Carefully cut the electrical tape.
  3. Disconnect electrical connectors.
  4. Replace the radio antenna cable.
  5. Secure the radio antenna cable within the electrical conduit.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.