Accessory and Liftgate Control Module Replacement (Enclave)

2014 Chevrolet Traverse LT, 4D UtilitySECTION Accessory and Liftgate Control Module Replacement (Enclave)
WARNING: This page is about a different car, the 2015 GMC Acadia, 2015 Chevrolet Traverse, and 2015 Buick Enclave. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Identifying Accessory & Liftgate Control Module (Enclave)
GM1868790Courtesy of GENERAL MOTORS COMPANY
Callout Component Name
1 Body Side Trim Panel Stow Compartment Door Assembly
2 Accessory and Liftgate Control Module

Procedure

  1. Disconnect the electrical connectors.
  2. Reprogram the accessory and liftgate control module if replaced. Refer to Control Module References .

TIP:Β  Push in the tab to release the module from the liftgate actuator assembly.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.