Rearview Driver Information Camera Replacement (Traverse)

2014 Chevrolet Traverse LT, 4D UtilitySECTION Rearview Driver Information Camera Replacement (Traverse)
WARNING: This page is about a different car, the 2015 GMC Acadia, 2015 Chevrolet Traverse, and 2015 Buick Enclave. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Rearview Driver Information Camera (Traverse)
GM2179559Courtesy of GENERAL MOTORS COMPANY
Callout Component Name
Preliminary Procedure 
Remove the liftgate outside handle. Refer to Liftgate Outside Handle Replacement (Acadia, Traverse) .
1 Rearview Camera Screw (Qty: 4)
CAUTION:

Refer to Fastener Caution .


Tighten 
2.5 N.m (22 lb in)
2 Rearview Camera
TIP:  Release tape to remove the wiring harness.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • You smell fuel, burning insulation, or see smoke.
  • Brakes feel soft, pull hard to one side, or make grinding noises.
  • The engine overheats, stalls repeatedly, or misfires under load.
  • You are missing required tools, torque specs, or safe lifting equipment.
  • You are not confident in the next step or safety outcome.