Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2014TRAVERSE LT, 4D UTILITYREPAIR AND DIAGNOSISENGINE PERFORMANCEFUEL DELIVERYENGINE CONTROLS AND FUEL - 3.6L (LLT) - REPAIR INSTRUCTIONSREPAIR INSTRUCTIONSTHROTTLE BODY ASSEMBLY REPLACEMENTREMOVAL PROCEDURE
2014 Chevrolet Traverse LT, 4D Utility
Removal Procedure
2014 Chevrolet Traverse LT, 4D UtilitySECTION Removal Procedure
- Remove the air cleaner outlet duct. Refer to Air Cleaner Outlet Duct Replacement .
- Disconnect the engine wiring harness electrical connector (2) from the electronic throttle control (1).
- Remove the throttle body bolts (3).
- Remove the throttle body (2) and gasket (2). Discard the gasket.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.