Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2014TRAVERSE LT, 4D UTILITYREPAIR AND DIAGNOSISENGINE PERFORMANCEFUEL DELIVERYENGINE CONTROLS AND FUEL - 3.6L (LLT) - REPAIR INSTRUCTIONSREPAIR INSTRUCTIONSTHROTTLE BODY ASSEMBLY REPLACEMENTINSTALLATION PROCEDURE
2014 Chevrolet Traverse LT, 4D Utility
Installation Procedure
2014 Chevrolet Traverse LT, 4D UtilitySECTION Installation Procedure
- Position a NEW throttle body gasket (1) and throttle body (2) to the upper intake manifold.
- Install the throttle body bolts (3).CAUTION: Refer to Fastener Caution .
Tighten
Tighten the bolts to 10 N.m (89 lb in).
- Connect the engine wiring harness electrical connector (2) to the electronic throttle control (1).
- Install the air cleaner outlet duct. Refer to Air Cleaner Outlet Duct Replacement .
- Perform the throttle learn procedure. Refer to Q38 Throttle Body: Throttle/Idle Learn .
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.