Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2014TRAVERSE LT, 4D UTILITYREPAIR AND DIAGNOSISENGINE PERFORMANCEFUEL DELIVERYENGINE CONTROLS AND FUEL - 3.6L (LLT) - REPAIR INSTRUCTIONSREPAIR INSTRUCTIONSFUEL PUMP REPLACEMENT (LLT)INSTALLATION PROCEDURE
2014 Chevrolet Traverse LT, 4D Utility
Installation Procedure
2014 Chevrolet Traverse LT, 4D UtilitySECTION Installation Procedure
- Use the EN-48896
alignment gauge to ensure that the camshaft lobe is in the base circle position. At base circle the tool will be flush with the head.NOTE: The camshaft must be in the base circle position before the high pressure fuel pump is installed.
- Lubricate the high pressure fuel pump cylinder head bore and roller lifter with camshaft prelube GM P/N 12345501 (Canadian P/N 992704) or equivalent.
- Install the high pressure fuel pump roller lifter (5).
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.