SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2014EXPRESS 2500 BASE, VAN CARGO, 6.6L ENG VIN LREPAIR AND DIAGNOSISENGINE MECHANICALSTARTERBATTERY, CHARGING SYSTEM AND STARTING SYSTEMREPAIR INSTRUCTIONS (BATTERY, CHARGING SYSTEM AND STARTING SYSTEM)BATTERY POSITIVE CABLE EXTENSION CABLE JUNCTION BLOCK REPLACEMENT (BATTERY, CHARGING SYSTEM AND STARTING SYSTEM)REMOVAL PROCEDURE (BATTERY, CHARGING SYSTEM AND STARTING SYSTEM)
2014 Chevrolet Express 2500 Base, Van Cargo, 6.6L Eng VIN L

Removal Procedure (Battery, Charging System And Starting System)

2014 Chevrolet Express 2500 Base, Van Cargo, 6.6L Eng VIN LSECTION Removal Procedure (Battery, Charging System And Starting System)
  1. Disconnect the auxiliary battery negative cable. Refer to Battery Negative Cable Disconnection and Connection .
    2. Fig 1: View Of Positive Extension Cable
    GM1665180Courtesy of GENERAL MOTORS COMPANY
  2. Remove the positive extension cable nut from the junction block and disconnect the cable.
  3. Remove the air cleaner assembly. Refer to Air Cleaner Assembly Replacement .
  4. Remove the air cleaner outlet duct. Refer to Air Cleaner Outlet Duct Replacement .
    5. Fig 2: Positive Cable And Intake Air Heater (IAH)
    GM1724827Courtesy of GENERAL MOTORS COMPANY
  5. Remove the positive extension cable nut from the intake air heater and disconnect the cable.
  6. Disconnect the wiring harness clips.
  7. Remove the battery positive cover from the underhood bused electrical center (UBEC).
  8. Remove the positive extension cable nut from the UBEC terminal stud.
  9. Remove the positive extension cable.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.