SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2014EXPRESS 2500 BASE, VAN CARGO, 6.6L ENG VIN LREPAIR AND DIAGNOSISENGINE MECHANICALSTARTERBATTERY, CHARGING SYSTEM AND STARTING SYSTEMREPAIR INSTRUCTIONS (BATTERY, CHARGING SYSTEM AND STARTING SYSTEM)BATTERY NEGATIVE CABLE REPLACEMENT (LGH-PRIMARY)REMOVAL PROCEDURE (BATTERY, CHARGING SYSTEM AND STARTING SYSTEM)
2014 Chevrolet Express 2500 Base, Van Cargo, 6.6L Eng VIN L

Removal Procedure (Battery, Charging System And Starting System)

2014 Chevrolet Express 2500 Base, Van Cargo, 6.6L Eng VIN LSECTION Removal Procedure (Battery, Charging System And Starting System)
  1. Disconnect the battery negative cable from the battery. Refer to Battery Negative Cable Disconnection and Connection .
    2. Fig 1: Identifying Battery Negative Body Ground Cable Bolt & Terminal
    GM2374824Courtesy of GENERAL MOTORS COMPANY
  2. Remove the battery negative cable ground bolt (1) and terminal (2), from the inner fender panel.
    3. Fig 2: Locating Battery Negative Body Ground Cable Bolt & Terminal
    GM2374825Courtesy of GENERAL MOTORS COMPANY
  3. Remove the battery negative frame ground bolt (1) and terminal (2), from the right chassis frame.
    4. Fig 3: View Of Battery Negative Cable Engine Ground Bolt & Terminal
    GM2383844Courtesy of GENERAL MOTORS COMPANY
  4. Disconnect the battery negative cable engine ground bolt (1) and terminal (2) from the right side engine block.
  5. Remove the battery negative cable from the vehicle.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.