Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2014EXPRESS 2500 BASE, VAN CARGO, 6.6L ENG VIN LREPAIR AND DIAGNOSISENGINE MECHANICALSTARTERBATTERY, CHARGING SYSTEM AND STARTING SYSTEMREPAIR INSTRUCTIONS (BATTERY, CHARGING SYSTEM AND STARTING SYSTEM)BATTERY CURRENT SENSOR REPLACEMENT (BATTERY, CHARGING SYSTEM AND STARTING SYSTEM)REMOVAL PROCEDURE (BATTERY, CHARGING SYSTEM AND STARTING SYSTEM)
2014 Chevrolet Express 2500 Base, Van Cargo, 6.6L Eng VIN L
Removal Procedure (Battery, Charging System And Starting System)
2014 Chevrolet Express 2500 Base, Van Cargo, 6.6L Eng VIN LSECTION Removal Procedure (Battery, Charging System And Starting System)
- Disconnect the instrument panel (I/P) harness electrical connector (1) from the battery current sensor.
- Remove the negative battery cable. Refer to Battery Negative Cable Replacement (V8) , Battery Negative Cable Replacement (V6) , Battery Negative Cable Replacement (LGH-Primary) .
- Cut the tie straps and electrical tape attaching the battery current sensor to the battery cable.
- Squeeze the negative battery cable branches together.
- Slide the battery current sensor (1) off of the negative battery cable.
NOTE:
Note the position of the battery current sensor prior to removal.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.