Rear Object Sensor Alarm Assembly Replacement (Object Detection System And Pedestrian Protection System)

2014 Chevrolet Express 2500 Base, Van Cargo, 6.6L Eng VIN LSECTION Rear Object Sensor Alarm Assembly Replacement (Object Detection System And Pedestrian Protection System)
Fig 1: Rear Object Sensor Alarm Assembly
GM3109008Courtesy of GENERAL MOTORS COMPANY
Rear Object Sensor Alarm Assembly Replacement

Callout Component Name
Preliminary Procedure 
Raise and support the vehicle. Refer to. Lifting and Jacking the Vehicle
1 Rear Object Sensor Alarm Assembly

Procedure

  1. Disconnect the electrical connector.
  2. Lift the locking tabs on the housing and remove the rear object sensor.
NOTE:

The rear object sensor is a one piece design. Do NOT twist the sensor cap to try and remove the cap.

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • You smell fuel, burning insulation, or see smoke.
  • Brakes feel soft, pull hard to one side, or make grinding noises.
  • The engine overheats, stalls repeatedly, or misfires under load.
  • You are missing required tools, torque specs, or safe lifting equipment.
  • You are not confident in the next step or safety outcome.