Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2014EXPRESS 2500 BASE, VAN CARGO, 6.6L ENG VIN LREPAIR AND DIAGNOSIS (SINGLE PAGE)BRAKESTRACTION CONTROLANTILOCK BRAKE SYSTEMREPAIR INSTRUCTIONSREAR WHEEL SPEED SENSOR REPLACEMENTREMOVAL PROCEDURE
2014 Chevrolet Express 2500 Base, Van Cargo, 6.6L Eng VIN L
Removal Procedure
2014 Chevrolet Express 2500 Base, Van Cargo, 6.6L Eng VIN LSECTION Removal Procedure
WARNING:
Refer to Brake Dust Warning .
- Raise the vehicle. Refer to Lifting and Jacking the Vehicle .
- For the left rear sensor, remove the leaf spring anchor plate. Refer to Leaf Spring Replacement (1500/3500) , Leaf Spring Replacement (4500 Series) .
- Disconnect the electrical connector.
- Remove the wheel speed sensor retaining bolt.
- Remove the wheel speed sensor and spacer block.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.