Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2014EXPRESS 2500 BASE, VAN CARGO, 6.6L ENG VIN LREPAIR AND DIAGNOSIS (SINGLE PAGE)BODY & FRAMEDOOR LOCKSKEYLESS ENTRY SYSTEM AND REMOTE FUNCTIONSREPAIR INSTRUCTIONSREMOTE CONTROL DOOR LOCK RECEIVER REPLACEMENTREMOVAL PROCEDURE
2014 Chevrolet Express 2500 Base, Van Cargo, 6.6L Eng VIN L
Removal Procedure
2014 Chevrolet Express 2500 Base, Van Cargo, 6.6L Eng VIN LSECTION Removal Procedure
- Remove the instrument panel (I/P) upper trim panel. Refer to Instrument Panel Upper Trim Pad Replacement .
- Disconnect the electrical connector (2) from the door lock receiver (1).
- Disengage the remote control door lock receiver (1) from the door lock receiver bracket.
- Remove the door lock receiver.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.