SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2014EXPRESS 2500 BASE, VAN CARGO, 6.6L ENG VIN LREPAIR AND DIAGNOSIS (SINGLE PAGE)ACCESSORIES & EQUIPMENTMEMORY MODULESSECONDARY AND CONFIGURABLE CUSTOMER CONTROL SYSTEMREPAIR INSTRUCTIONSSTEERING WHEEL CONTROL SWITCH ASSEMBLY REPLACEMENT
2014 Chevrolet Express 2500 Base, Van Cargo, 6.6L Eng VIN L

Steering Wheel Control Switch Assembly Replacement

2014 Chevrolet Express 2500 Base, Van Cargo, 6.6L Eng VIN LSECTION Steering Wheel Control Switch Assembly Replacement
Fig 1: Steering Wheel Control Switch Assembly
GM1915283Courtesy of GENERAL MOTORS COMPANY
Steering Wheel Control Switch Assembly Replacement

Callout Component Name
Preliminary Procedure 
Remove the inflatable restraint steering wheel module. Refer to Airbag Steering Wheel Module Replacement .
1 Steering Wheel Trim Plate Screw (Qty: 4)
CAUTION:

Refer to Fastener Caution .


Tighten 
2 N.m (18 lb in)
2 Steering Wheel Trim Plate (Qty: 2)
3 Radio Control Screw (Qty: 6)
CAUTION:

Refer to Fastener Caution .


Tighten 
2 N.m (18 lb in)
4 Radio Control Switch Assembly

Procedure

  1. Disconnect the electrical connector.
  2. Make sure the steering wheel control switches are properly seated to the steering wheel trim cover during installation.
5 Cruise Control Switch Assembly

Procedure

  1. Disconnect the electrical connector.
  2. Make sure the steering wheel control switches are properly seated to the steering wheel trim cover during installation.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.