Circuit/System Testing (Object Detection System And Pedestrian Protection System)

2014 Chevrolet Express 2500 Base, Van Cargo, 6.6L Eng VIN LSECTION Circuit/System Testing (Object Detection System And Pedestrian Protection System)
  1. Ignition OFF, disconnect the harness connector at the rearview camera.
  2. Ignition ON, park brake applied, transmission in REVERSE, test for B+ between the B+ circuit terminal 3 and ground.
    • If less than the specified value, test the B+ circuit for a short to ground or an open/high resistance.
  3. If all circuits test normal, replace the BCM.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.