SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2014EQUINOX LS, FWD, GAS/ETHANOLREPAIR AND DIAGNOSISENGINE PERFORMANCETESTING & DIAGNOSISDATA COMMUNICATION SYSTEMDIAGNOSTIC INFORMATION AND PROCEDURESDTC U0100 - U02FF: CONTROL MODULECIRCUIT/SYSTEM VERIFICATION
2014 Chevrolet Equinox LS, FWD, Gas/Ethanol

Circuit/System Verification

2014 Chevrolet Equinox LS, FWD, Gas/EthanolSECTION Circuit/System Verification
  1. Determine the device that is not communicating. Refer to Control Module U Code List .
  2. Verify that DTC U0073, U2100, U0074, U0078, U1814, U2099, B1325, B1330, B1370, B1380, B1424, B1440, B1441, B1517, C0800, C0899, C12E1, P0560, or P0562 is not set.
    • If none of the DTCs are set 
  3. Verify that DTC U0125 and DTC U0126 are not set.
    • If both of the DTCs are not set together 
  4. Verify that DTC U0101 5A is not set by K17 Electronic Brake Control Module.
    • If the DTC is not set 
  5. Engine running for 10 seconds.
  6. Ignition ON, engine OFF, verify that DTC U0100-U02FF is not set.
    • If the DTC U0100-U02FF is set in any device, except the K17 Electronic Brake Control Module 

      Refer to Circuit/System Testing.

    • If the DTC U0100-U02FF is set in the K17 Electronic Brake Control Module with any symptom byte, except symptom bytes 71, 72, and 74 

      Refer to Circuit/System Testing.

    • If the DTC U0100-U02FF is set in the K17 Electronic Brake Control Module with symptom byte 71, 72, or 74 along with other DTCs set 

      Diagnose all other DTCs first. Refer to Diagnostic Trouble Code (DTC) List - Vehicle .

    • If the DTC U0100-U02FF is set in the K17 Electronic Brake Control Module with symptom byte 71, 72, or 74 and without other DTCs set 
    1. Program the K17 Electronic Brake Control Module.
    2. Verify the DTC does not set.
      • If the DTC sets, replace the K17 Electronic Brake Control Module.
      • If the DTC does not set
    3. All OK.
    • If the DTC U0100-U02FF is not set 
  7. All OK.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.