SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2014EQUINOX LS, FWD, GAS/ETHANOLREPAIR AND DIAGNOSISENGINE MECHANICALSTARTERBATTERY, CHARGING SYSTEM AND STARTING SYSTEMREPAIR INSTRUCTIONSSTARTER REPLACEMENT (LFX)INSTALLATION PROCEDURE
2014 Chevrolet Equinox LS, FWD, Gas/Ethanol

Installation Procedure

2014 Chevrolet Equinox LS, FWD, Gas/EthanolSECTION Installation Procedure
    Fig 1: Starter Motor And Bolts
    GM2201749Courtesy of GENERAL MOTORS COMPANY
  1. Install the starter motor (2).
    2. CAUTION:

    Refer to Fastener Caution .

  2. Install the starter motor mounting bolts. Tighten to 50 N.m (37 lb ft).
    3. Fig 2: View Of Starter Solenoid, Engine Harness Connector & Battery Positive Nut
    GM2196014Courtesy of GENERAL MOTORS COMPANY
  3. Install the battery positive cable and engine harness connector to the starter. Tighten the battery positive cable nut (1) to 13 N.m (115 lb in).
  4. Install the engine harness connector to the starter solenoid.
    5. Fig 3: View Of Starter & Heat Shield
    GM2196015Courtesy of GENERAL MOTORS COMPANY
  5. Install the starter heat shield (2) and tighten the bolt (1) to 5 N.m (44 lb in).
  6. Connect the knock sensor connector.
  7. Install and connect the bank 1 sensor 2 oxygen sensor.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.