Installation Procedure

2014 Chevrolet Equinox LS, FWD, Gas/EthanolSECTION Installation Procedure
    Fig 1: View Of Starter Motor
    GM2102330Courtesy of GENERAL MOTORS COMPANY
  1. Position the starter (1) to the engine.
  2. CAUTION:

    Refer to Fastener Caution .

  3. Install the starter bolts (2) and tighten to 50 N.m (37 lb ft).
  4. Fig 2: View Of Starter Motor, Bolts & Cable
    GM2102329Courtesy of GENERAL MOTORS COMPANY
  5. Install the starter solenoid wire terminal (2) to the starter.
  6. Install the positive battery cable terminal (3) to the starter Ensure that the anti-rotational tab is correctly located into the indexing slot.
  7. Install the starter solenoid terminal nut (4) and tighten to 10 N.m (89 lb in).
  8. Connect the engine harness connector (1) to the starter.
  9. Install the power vacuum brake booster pump. Refer to Power Brake Booster Pump Replacement
  10. Lower the vehicle.
  11. Connect the negative battery cable. Refer to Battery Negative Cable Disconnection and ConnectionΒ .
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.