Installation Procedure

2014 Chevrolet Equinox LS, FWD, Gas/EthanolSECTION Installation Procedure
    Fig 1: Idler Pulley Bolt And Generator
    GM2196009Courtesy of GENERAL MOTORS COMPANY
  1. Position the generator (4) to the engine.
  2. Loosely install the generator bolts (3).
  3. Install the idler pulley. Refer to Drive Belt Idler Pulley Replacement .
  4. CAUTION:

    Refer to Fastener Caution .

  5. Tighten the generator bolts to 50 N.m (37 lb ft).
  6. Fig 2: Identifying Generator, Electrical Harness Connector & Nut
    GM2196013Courtesy of GENERAL MOTORS COMPANY
  7. Install the drive belt. Refer to Drive Belt Replacement .
  8. Connect the engine harness electrical connector (1) to the generator.
  9. Install the positive battery cable terminal (3) to the generator.
  10. Install the positive battery cable nut (2) at the generator and tighten to 20 N.m (15 lb ft).
  11. Position the positive battery cable boot at the generator terminal.
  12. Connect the negative battery cable. Refer to Battery Negative Cable Disconnection and ConnectionΒ .
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.