Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2014EQUINOX LS, FWD, GAS/ETHANOLREPAIR AND DIAGNOSISBODY & FRAMEDOOR LOCKSPOWER DOOR LOCK SYSTEM AND RELEASE SYSTEMSREPAIR INSTRUCTIONSLIFTGATE LOCK STRIKER REPLACEMENT
2014 Chevrolet Equinox LS, FWD, Gas/Ethanol
Liftgate Lock Striker Replacement
2014 Chevrolet Equinox LS, FWD, Gas/EthanolSECTION Liftgate Lock Striker Replacement
Liftgate Lock Striker Replacement
| Callout | Component Name |
|---|---|
| Preliminary Procedure Remove the rear end trim finish panel. Refer to Rear End Trim Finish Panel Replacement . |
|
| 1 | Liftgate Lock Striker Bolt (Qty: 2)
CAUTION:
Refer to Fastener Caution . Tighten 25 N.m (18 lb ft) |
| 2 | Liftgate Lock Striker Procedure
|
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.