Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2014EQUINOX LS, FWD, GAS/ETHANOLREPAIR AND DIAGNOSISBODY & FRAMEDOOR LOCKSPOWER DOOR LOCK SYSTEM AND RELEASE SYSTEMSREPAIR INSTRUCTIONSLIFTGATE CALIBRATIONGARAGE HEIGHT CALIBRATION
2014 Chevrolet Equinox LS, FWD, Gas/Ethanol
Garage Height Calibration
2014 Chevrolet Equinox LS, FWD, Gas/EthanolSECTION Garage Height Calibration
If any portion of the power liftgate assembly is replaced, repaired or disassembled, perform the following liftgate calibration procedure:
- Ensure that the rotary switch on the overhead console is set to Garage.
- Open the liftgate to the desired height manually
- Hold the liftgate close switch for at least 3 seconds with the liftgate at the desired height.
- Close the liftgate completely using one of the following switches:
- The rotary switch on the overhead console or driver door panel
- The liftgate close switch on the liftgate
- The remote control switch on the key fob
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.