Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2014EQUINOX LS, FWD, GAS/ETHANOLREPAIR AND DIAGNOSIS (SINGLE PAGE)QUICK LOOKUPSWIRING DIAGRAMSWIRING SYSTEMS AND POWER MANAGEMENT - COMPONENT CONNECTOR END VIEWS - K20 (X1 - LFX) TO K85COMPONENT CONNECTOR END VIEWSK47 REAR DIFFERENTIAL CLUTCH CONTROL MODULE X2 (F46)
2014 Chevrolet Equinox LS, FWD, Gas/Ethanol
K47 Rear Differential Clutch Control Module X2 (F46)
2014 Chevrolet Equinox LS, FWD, Gas/EthanolSECTION K47 Rear Differential Clutch Control Module X2 (F46)
Connector Part Information
|
Terminal Part Information
| Terminal Type ID | Terminated Lead | Diagnostic Test Probe | Terminal Removal Tool | Service Terminal | Tray | Core Crimp | Insulation Crimp |
|---|---|---|---|---|---|---|---|
| I | 13575865 | J-35616-64B (LBU) | J-38125-215A | SAIT-A03GF-M064 | 27 | P | P |
K47 Rear Differential Clutch Control Module X2 (F46)
| Pin | Size | Color | Circuit | Function | Terminal Type ID | Option |
|---|---|---|---|---|---|---|
| 1 | - | - | - | Not Occupied | - | - |
| 2 | 0.35 | BK | 987 | Rear Drive Motor Control | I | - |
| 3 | 0.35 | BK | 934 | Limited Slip Differential Valve Control | I | - |
| 4 | 0.35 | BK | 933 | Rear Drive Motor Control | I | - |
| 5 | 0.35 | BK | 935 | Limited Slip Differential Valve Control | I | - |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.