Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2014EQUINOX LS, FWD, GAS/ETHANOLREPAIR AND DIAGNOSIS (SINGLE PAGE)QUICK LOOKUPSELECTRICAL COMPONENT LOCATIONSELECTRICAL COMPONENT LOCATOR - POWERTRAIN COMPONENT VIEWSPOWERTRAIN COMPONENT VIEWSLEFT FRONT ENGINE COMPONENTS (LFX)
2014 Chevrolet Equinox LS, FWD, Gas/Ethanol
Left Front Engine Components (LFX)
2014 Chevrolet Equinox LS, FWD, Gas/EthanolSECTION Left Front Engine Components (LFX)
Left Front Engine Components (LFX)
| Items |
|---|
| 1: T8B Ignition Coil 2 T8B Ignition Coil 2 (LFX) |
| 2: T8D Ignition Coil 4 T8D Ignition Coil 4 (LFX) |
| 3: T8F Ignition Coil 6 (LFX) T8F Ignition Coil 6 (LFX) |
| 4: G18 High Pressure Fuel Pump G18 High Pressure Fuel Pump |
| 5: B34 Engine Coolant Temperature Sensor B34 Engine Coolant Temperature Sensor (LFX) |
| 6: M64 Starter Motor M64 Starter Motor X1M64 Starter Motor X2 (Generator Harness) (LFX)M64 Starter Motor X2 (Positive Battery Cable) (LFX) |
| 7: B68B Knock Sensor 2 (LFX) B68B Knock Sensor 2 (LFX) |
| 8: B37 Engine Oil Pressure Switch B37 Engine Oil Pressure Switch (LFX) |
| 9: B1 A/C Refrigerant Pressure Sensor B1 A/C Refrigerant Pressure Sensor |
| 10: Q2 A/C Compressor Clutch Q2 A/C Compressor Clutch |
| 11: G13 Generator G13 Generator X1G13 Generator X2 |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.