SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2014EQUINOX LS, FWD, GAS/ETHANOLREPAIR AND DIAGNOSIS (SINGLE PAGE)ACCESSORIES & EQUIPMENTENTERTAINMENT SYSTEMSCELLULAR SYSTEM, ENTERTAINMENT SYSTEM, AND NAVIGATION SYSTEM - REPAIR INSTRUCTIONSREPAIR INSTRUCTIONSCOMMUNICATION INTERFACE MODULE REPLACEMENT
2014 Chevrolet Equinox LS, FWD, Gas/Ethanol

Communication Interface Module Replacement

2014 Chevrolet Equinox LS, FWD, Gas/EthanolSECTION Communication Interface Module Replacement
Fig 1: Communication Interface Module
GM2244748Courtesy of GENERAL MOTORS COMPANY
Communication Interface Module Replacement

Callout Component Name
Preliminary Procedure 
Remove the driver side knee bolster reinforcement. Refer to Driver Knee Bolster Reinforcement Replacement (Equinox) , Driver Knee Bolster Reinforcement Replacement (Terrain)
1 Communication Interface Module Bolt (Qty: 2)
CAUTION:

Refer to Fastener Caution .


Tighten 
10 N.m (89 lb in)
2 Communication Interface Module

Procedure

  1. Disconnect the electrical connections.
  2. If replacing the communication interface module be sure to transfer bluetooth antenna, if equipped.
  3. For programming and set up procedures, refer to Control Module References
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.