Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2014EQUINOX LS, FWD, GAS/ETHANOLREPAIR AND DIAGNOSIS (SINGLE PAGE)ACCESSORIES & EQUIPMENTDRIVERS ASSISTANCE SYSTEMS - ADASOBJECT DETECTION SYSTEM AND PEDESTRIAN PROTECTION SYSTEMDIAGNOSTIC INFORMATION AND PROCEDURESSYMPTOMS - OBJECT DETECTIONNOTES
2014 Chevrolet Equinox LS, FWD, Gas/Ethanol
Symptoms - Object Detection: Notes
2014 Chevrolet Equinox LS, FWD, Gas/EthanolSECTION Notes
NOTE:
The following steps must be completed before using the symptom tables:
- Perform the Diagnostic System Check - Vehicle
before using the Symptom List in order to verify that all of the following are true:
- There are no DTCs set.
- The control modules can communicate via the serial data link.NOTE:
The rear vision camera does not communicate on the serial data bus.
- Review the system operation in order to familiarize yourself with the system functions. Refer to Object Detection Description and Operation (Forward Collision Alert, UEU) , Object Detection Description and Operation (Lane Departure Warning, UFL) , Object Detection Description and Operation (Rear Vision Camera, UVC) , Object Detection Description and Operation (Side Blind Zone Alert, UFT) , Object Detection Description and Operation (Rear Park Assist, UD7) .
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.