Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2014EQUINOX LS, FWD, GAS/ETHANOLREPAIR AND DIAGNOSIS (SINGLE PAGE)ACCESSORIES & EQUIPMENTCOMMUNICATION DEVICESPROGRAMMING AND SETUP - ALL SYSTEMSREPAIR INSTRUCTIONSCONTROL SOLENOID VALVE AND TRANSMISSION CONTROL MODULE ASSEMBLY PROGRAMMING AND SETUP (6T30/6T40/6T45/6T50)TCM REPROGRAMMING
2014 Chevrolet Equinox LS, FWD, Gas/Ethanol
TCM Reprogramming
2014 Chevrolet Equinox LS, FWD, Gas/EthanolSECTION TCM Reprogramming
- Use a scan tool to view and record the Transmission Control Module - End Model Part Number in the original TCM prior to starting the TCM reprogramming procedure.
- In some cases, the TCM and ECM may have to be reprogrammed. When a selection for TCM Transmission Control Module - Programming is not available, select SEQ Programming Sequence ECM/TCM (Automatic Transmission Only).
- If the TCM needs to be reprogrammed. Refer to Service Programming System (SPS) .
- Perform the Transmission Adaptive Values Learn. Refer to Transmission Adaptive Values Learn .
NOTE:
- Turn the ignition OFF for 30 seconds.
- Turn the ignition ON with the engine OFF.
- Use the scan tool in order to retrieve history DTCs from all modules.
- Clear all history DTCs.
NOTE:
After programming, perform the following to avoid future misdiagnosis:
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.