SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2014CAMARO ZL1, 2D CONVERTIBLE, STANDARD TRANSREPAIR AND DIAGNOSISSTEERINGSTEERING WHEEL AND STEERING COLUMNREPAIR INSTRUCTIONSTURN SIGNAL SWITCH BRACKET REPLACEMENT
2014 Chevrolet Camaro ZL1, 2D Convertible, Standard Trans

Turn Signal Switch Bracket Replacement

2014 Chevrolet Camaro ZL1, 2D Convertible, Standard TransSECTION Turn Signal Switch Bracket Replacement
Fig 1: Turn Signal Switch Bracket And Fasteners
GM2222894Courtesy of GENERAL MOTORS COMPANY
Callout Component Name
Preliminary Procedure 
Remove the steering wheel airbag coil. Refer to Steering Wheel Airbag Coil Replacement .
1 Turn Signal Switch Bracket Fastener (Qty:2)
2 Turn Signal Switch Bracket

Procedure

  1. Disconnect any electrical connectors as necessary.
  2. Transfer any parts as necessary. Refer to Turn Signal Multifunction Switch Replacement , and to Windshield Wiper and Washer Switch Replacement .
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.