Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2014CAMARO ZL1, 2D CONVERTIBLE, STANDARD TRANSREPAIR AND DIAGNOSISELECTRICALWIRING DIAGRAMSWIRING SYSTEMS AND POWER MANAGEMENT - COMPONENT CONNECTOR END VIEWS - Q17C TO X85COMPONENT CONNECTOR END VIEWSS3 TRANSMISSION SHIFT LEVER
2014 Chevrolet Camaro ZL1, 2D Convertible, Standard Trans
S3 Transmission Shift Lever
2014 Chevrolet Camaro ZL1, 2D Convertible, Standard TransSECTION S3 Transmission Shift Lever
Connector Part Information
|
Terminal Part Information
| Terminal Type ID | Terminated Lead | Diagnostic Test Probe | Terminal Removal Tool | Service Terminal | Tray | Core Crimp | Insulation Crimp |
|---|---|---|---|---|---|---|---|
| I | 13575492 | J-35616-2A (GY) | J-38125-29 | Not Available | Not Available | Not Available | Not Available |
| Pin | Size | Color | Circuit | Function | Terminal Type ID | Option |
|---|---|---|---|---|---|---|
| A | 0.5 | BK | 1550 | Ground | I | - |
| B | - | - | - | Not Occupied | - | - |
| C | 0.35 | TN | 7553 | Park Lock Solenoid Control | I | - |
| D | - | - | - | Not Occupied | - | - |
| E | 0.5 | YE | 6817 | LED Backlight Dimming Control | I | - |
| F | - | - | - | Not Occupied | - | - |
| G | 0.5 | PU/WH | 5905 | Key Capture/Column Lock Shift Position Signal | ||
| H | - | - | - | Not Occupied | - | - |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.