SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2014CAMARO ZL1, 2D CONVERTIBLE, STANDARD TRANSREPAIR AND DIAGNOSISBODY & FRAMEWINDOWSFIXED AND MOVEABLE WINDOW SYSTEMREPAIR INSTRUCTIONSWINDSHIELD FRAME WEATHERSTRIP REPLACEMENT
2014 Chevrolet Camaro ZL1, 2D Convertible, Standard Trans

Windshield Frame Weatherstrip Replacement

2014 Chevrolet Camaro ZL1, 2D Convertible, Standard TransSECTION Windshield Frame Weatherstrip Replacement
Fig 1: Windshield Frame Weatherstrip, Nuts & Retainers
GM2524630Courtesy of GENERAL MOTORS COMPANY
Callout Component Name

Preliminary Procedures

  1. Place the folding top in the full down position.
  2. Remove the left and right side windshield side garnish molding. Refer to Windshield Side Garnish Molding Replacement (Coupe)Windshield Side Garnish Molding Replacement (Convertible) .
1 Windshield Frame Weatherstrip Retainer (Qty:2)
Procedure 
Remove the windshield frame weatherstrip retainers located in the left and right ends of the weatherstrip.
2 Windshield Frame Weatherstrip Nut (Qty:2)
CAUTION:

Refer to Fastener Caution .


Tighten 
10 N.m (89 lb in)
3 Windshield Frame Weatherstrip

Procedure

  1. Remove the weatherstrip from the windshield frame channel, full the weatherstrip gently to disengage the foam adhesive tape.
  2. Use a solution of 50/50 isopropyl alcohol and water to clean the adhesive surface.
  3. The upper inner part of the weatherstrip lip must be over the header garnish molding for a good seal.

TIP:  Water test the vehicle to ensure no leaks.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.