SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2014CAMARO ZL1, 2D CONVERTIBLE, STANDARD TRANSREPAIR AND DIAGNOSISBODY & FRAMEWINDOWSFIXED AND MOVEABLE WINDOW SYSTEMREPAIR INSTRUCTIONSREAR WINDOW UPPER REVEAL MOLDING REPLACEMENT
2014 Chevrolet Camaro ZL1, 2D Convertible, Standard Trans

Rear Window Upper Reveal Molding Replacement

2014 Chevrolet Camaro ZL1, 2D Convertible, Standard TransSECTION Rear Window Upper Reveal Molding Replacement
Fig 1: Rear Window Upper Reveal Molding & Retainers
GM2425002Courtesy of GENERAL MOTORS COMPANY
Callout Component Name
1 Rear Window Upper Reveal Molding Retainer (Qty:4)
2 Rear Window Upper Reveal Molding

Procedure

  1. Open the rear compartment lid in order to access the rear lamp electrical harness.
  2. Disengage the electrical grommet from the rear window drain panel.
  3. Disconnect the electrical connector from the rear lamp electrical harness.
  4. Apply tape around the outside perimeter of the reveal molding.
  5. Using a plastic tool, apply adequate pressure upward to release the retainers and reveal molding from the vehicle.
  6. Replace all broken retainers
  7. Transfer the high mount stop lamp.

TIP:  Using a suitable tool, insert the grommet into the rear window drain panel.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.