Windshield Wiper Transmission Replacement

2014 Chevrolet Camaro ZL1, 2D Convertible, Standard TransSECTION Windshield Wiper Transmission Replacement
Fig 1: Windshield Wiper Transmission And Bolts
GM2199655Courtesy of GENERAL MOTORS COMPANY
Callout Component Name
Preliminary Procedure 
Remove the air inlet grille panel assembly. Refer to Air Inlet Grille Panel Replacement .
1 Windshield Wiper Transmission Bolt (Qty:3)
CAUTION:

Refer to Fastener Caution .


Tighten 
5.5 N.m (49 lb in)
2 Windshield Wiper Transmission

Procedure

  1. Lift the front edge of the wiper transmission out from the plenum.
  2. Disconnect the wiper motor electrical connector.
  3. Remove the wiper transmission assembly from the vehicle.
  4. Remove the windshield wiper motor from the transmission. Refer to Windshield Wiper Motor Replacement .
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • You smell fuel, burning insulation, or see smoke.
  • Brakes feel soft, pull hard to one side, or make grinding noises.
  • The engine overheats, stalls repeatedly, or misfires under load.
  • You are missing required tools, torque specs, or safe lifting equipment.
  • You are not confident in the next step or safety outcome.