SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2014CAMARO ZL1, 2D CONVERTIBLE, STANDARD TRANSREPAIR AND DIAGNOSISACCESSORIES & EQUIPMENTWIPER/WASHER SYSTEMSWIPER SYSTEM AND WASHER SYSTEMREPAIR INSTRUCTIONSWINDSHIELD WIPER ARM REPLACEMENT (V6)
2014 Chevrolet Camaro ZL1, 2D Convertible, Standard Trans

Windshield Wiper Arm Replacement (V6)

2014 Chevrolet Camaro ZL1, 2D Convertible, Standard TransSECTION Windshield Wiper Arm Replacement (V6)
Fig 1: Windshield Wiper Arm (V6)
GM2183100Courtesy of GENERAL MOTORS COMPANY
Callout Component Name
Preliminary Procedure 
Open and support the hood.
1 Windshield Wiper Arm Nut Cap
NOTE:

Use a small flat-bladed tool in order to release the cap from the wiper arm.
2 Windshield Wiper Arm Nut
CAUTION:

Refer to Fastener Caution .


Tighten 
38 N.m (28 lb ft)
3 Windshield Wiper Arm

Procedure

  1. Grasp the outer end of the wiper arm and rock the arm back and forth while holding the wiper blade off the windshield.
  2. Lift the arm assembly from the wiper motor pivot shaft.
  3. Clean the knurls on the wiper motor pivot shaft with a soft wire brush.
  4. Align the wiper blade to the small clear circles in the lower windshield blackout and hold into position while torquing the nut.
  5. Electrically cycle the wiper arms and re-check the blade alignment to the lower windshield alignment circles.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.