SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2014CAMARO ZL1, 2D CONVERTIBLE, STANDARD TRANSREPAIR AND DIAGNOSISACCESSORIES & EQUIPMENTINFOTAINMENTCELLULAR SYSTEM, ENTERTAINMENT SYSTEM, AND NAVIGATION SYSTEM - REPAIR INSTRUCTIONSREPAIR INSTRUCTIONSRADIO ANTENNA BASE REPLACEMENT (CONVERTIBLE)
2014 Chevrolet Camaro ZL1, 2D Convertible, Standard Trans

Radio Antenna Base Replacement (Convertible)

2014 Chevrolet Camaro ZL1, 2D Convertible, Standard TransSECTION Radio Antenna Base Replacement (Convertible)
Fig 1: Radio Antenna Base (Convertible)
GM2526006Courtesy of GENERAL MOTORS COMPANY
Callout Component Name
Preliminary Procedure 
Remove the rear compartment lid finish panel. Refer to Rear Compartment Lid Carpet Replacement (Convertible) .
1 Radio Antenna Base
CAUTION:

Refer to Fastener Caution .

Procedure

  1. Remove the integral bolt and retainer.
  2. Disconnect the electrical connections.
  3. Disconnect the antenna cables.
  4. Feed the wiring and cable up through the hole in the rear compartment lid panel.

Tighten 
9 N.m (80 lb in)
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.