Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

SYS.OK|MANUAL.DB● LIVE

HOMESERVICE MANUALSCHEVROLET2014CAMARO ZL1, 2D CONVERTIBLE, STANDARD TRANSREPAIR AND DIAGNOSIS (SINGLE PAGE)ACCESSORIES & EQUIPMENTCOMMUNICATION DEVICESPROGRAMMING AND SETUP - ALL SYSTEMSREPAIR INSTRUCTIONSRADIO PROGRAMMING AND SETUPRADIO PROGRAMMING AND SETUP (WITHOUT UYE)REPROGRAM CONTROL MODULE

2014 Chevrolet Camaro ZL1, 2D Convertible, Standard Trans

Reprogram Control Module

2014 Chevrolet Camaro ZL1, 2D Convertible, Standard TransSECTION Reprogram Control Module

To reprogram an existing control module, perform the following procedure:

Install the EL-49642 SPS Programming Support Tool.
Connect a USB drive to the computer.
NOTE:
If using a pre-configured USB drive supplied by General Motors, proceed to step 6.
Access the Service Programming System (SPS) and follow the on-screen instructions.
On the SPS Supported Controllers screen, select A11 Radio - USB File Transfer, and follow the on-screen instructions.
NOTE:
- If there are no files available for USB transfer via SPS, proceed to step 11.
- All existing files on the USB drive will be erased when the new files are copied.
Upon completion of the file transfer, remove the USB drive from the computer.
Ignition ON, radio ON.
Connect the USB drive to the USB port in the vehicle.
Using the radio controls, select the following: Config>Radio Settings>Software Versions Menu>Update Radio Software. Follow the infotainment display on-screen instructions and select Update when prompted. Programming will take several minutes.
When programming is complete, remove the USB device from the vehicle USB port.
Access the Service Programming System (SPS) and follow the on-screen instructions.
On the SPS Supported Controllers screen, select A11 Radio - Programming, and follow the on-screen instructions.
At the end of programming, choose the "Clear DTCs" function on the SPS screen.

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready Tools Free Quote Check Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.